Asymmetric reducer for round air ducts, useful for connect components with different diameters maintaining a connection clean and stable. Ideal for switch from Ø125 mm a Ø150 mm in a system ducted.
Key features
- Type: reducer asymmetric for round ducts
- Connection diameters: 125 / 150 mm
- Material: plastic (white)
- Dimensions (datasheet): a 60 mm; D1 154 mm; D2 150 mm; D3 121 mm; D4 125 mm
Overview
What it is for
It is used to connect two sections of ducting circular with different diameters (Ø125 and Ø150 mm), facilitating installations and modifications of the air system.
Who it is for
For those who must integrate accessories or sections of duct Ø150 mm on a line esistente Ø125 mm (or viceversa).
What makes it different
The profile asymmetric helps when the clearances or alignment not consentono a reducer centrata.
How to use and tips
Installation
- Individua the side Ø125 mm and the side Ø150 mm in basis to the ducting.
- Insert the reducer between the two elements and complete the mounting (clamps/sealing according to practice d’system).
- Check sealing and stability before of the use continuous.
Adjustment
None is required.
Maintenance
- Inspect periodically the joints and restore the clamping if necessary.
Warnings
- Install a system switched off and in safety.
- Make sure of the compatibility for diameter nominal before of the installation.
Technical specifications
- Connection diameters: 125 / 150 mm
- Material: plastic (white)
- Dimensions (datasheet): a 60 mm; D1 154 mm; D2 150 mm; D3 121 mm; D4 125 mm
FAQ
Can THE montarla in qualunque direction?
Va montata observing the diameters nominali of the two lati (Ø125 and Ø150 mm) in basis ai components from connect.
Is used a sigillante?
Depends dai requisiti of the system: a good sealing can improve the sealing of the ducting.